How to clean the semi-automatic washing machine

Friendly tips: the full text is about 3094 words. Please read it patiently. Keyword tags: Tips for cleaning the old semi-automatic washing machine. Cut off the power supply of the semi-automatic washing machine, open the cover of the washing machine, remove the rotating blade at the bottom of the barrel with a screwdriver and wash it. Remove the plastic dirt tank boxes on both sides of the cylinder wall of the washing machine, and clean the wool in the box with transparent tape. Replace the cleaned rotating blade, pour in the special detergent or cleaning powder for the washing machine, start the washing machine and select the cleaning cylinder mode. Turn off the power after the washing machine runs for 10 minutes, and then start it after standing for 2 hours until it is drained. The following is a detailed introduction: how to clean the semi-automatic washing machine 1. Cut off the power first! The washing machine can be operated directly without moving its position. Open the cover of the washing machine, loosen the screw with a screwdriver, take it off, pull the raised blade up with both hands and take it off. If there is water, dry it with a towel before taking it; Step 2. The back of the removed blade is like this. It was cleaned once 3 months ago. It can be seen that it is so dirty, so it is very necessary to clean the washing machine regularly. After the blade is removed, you can see that there are 4 screws at the bottom. You can unscrew them with a screwdriver and put them in place; Step 3. Then start to remove the cover, one such screw on the left and right outside the washing machine, pry off the shell and unscrew the screw. There are two more in the back. Screw them off, too. After unscrewing the four screws on the outside of the upper cover, you can lift the upper cover. Be very careful at this time! The upper cover can't be completely removed because it is connected with water pipes and wires. We can only turn it back and find a support for it; Step 4. At this time, you will find that there is a cover on the drum. Unscrew four screws and take it off easily; Step 5. In step 2, we unscrewed the four screws under the blade. At this time, we only need to shake the inner barrel to lift out the inner barrel. We usually see that the inner wall of the inner barrel is very clean. When we take out the inner barrel, we find that the outer wall of the inner barrel is so dirty, and we can see that the bottom of the outer barrel is also very dirty; Step 6. The next step is cleaning. Just clean the inner wall of the inner barrel with a rag or brush. We only dismantle and wash the outer barrel. Don't move! Pour water in a bucket and then brush it with a brush. After brushing, you need to turn on the power supply and directly select dehydration. These sewage can be discharged. It will take on a new look after several more times. The above is the disassembly and cleaning process of the semi-automatic washing machine. In this process, you must pay attention to be careful when removing the upper cover. There are many steps, but it is not complicated. Go and clean your washing machine!