Sihai network

How to remove transparent tape offset? How to remove the offset on the wall

Transparent tape is used in many places, many scenes, and there may be the shadow of transparent tape in the corner of home, company, etc. But after using, the Yellow offset will be left on the wall, which is very difficult to remove. So what's your good idea?

Here are 12 tips for degumming collected by Xiaobian:

1. The method of removing the adhesive: soak the place with adhesive completely with the adhesive, and wipe it off with dry cloth after 15 minutes. If the dirt is difficult to remove, you can extend the immersion time of Aeolian essence, and then rub hard until it is cleaned.

2. Hair dryer heating offset printing: turn the hair dryer to the maximum heat, blow it against the tape trace for a while, make it soft, and then wipe off the offset printing easily with a harder eraser or a soft rag. Scope of application: this method is applicable to the products with small tape trace and long offset existence time, but the products should have enough heat resistance.

3. Method to remove the adhesive of vinegar: dip the white vinegar or vinegar with a dry dishcloth, completely cover the labeled part, and make it fully soaked. After soaking for 15-20 minutes, gradually wipe with dishcloth along the edge of the sticker.

4. Lemon juice to remove the adhesive method: squeeze the lemon juice on the hand with adhesive dirt, rub repeatedly, and then remove the adhesive mark.

5. Medical alcohol immersion offset printing: drop some medical essence on the surface with the traces of offset printing and soak it for a while. Then wipe it off with a soft cloth or paper towel. Of course. The surface of the objects with tape marks must be the kind that is not afraid of alcohol corrosion before using this method. If there are expired perfume or effective make-up water, it can also be used to replace spit, because there are certain spice ingredients in it. And these two can be applied to any item. The alcohol in biding is not too much. Scope of application: the surface of articles that are not easy to be corroded.

6. Remove the adhesive with acetone: the method is the same as above. The best thing is that it can remove the residual gum very quickly and easily, which is better than sprinkling essence. Both of the above are solvents and are the best of all methods.

7. Use banana water to remove the adhesive: it's an industrial agent used to remove the paint, and it's easy to buy. The method is the same as that of alcohol acetone.

8, wash the nail polish to remove offset printing: no matter how long the history is, and the large area of offset printing, just drop some girls to wash nail polish, wash them for a while, then wipe them with paper towels to ensure that the surface of the products is clean and new. But there is a problem. Because the nail polish has strong corrosiveness, it can not be used on the surface of the products which are afraid of corrosion. For example: lacquer furniture, laptop shell, etc. Therefore, although it is very useful to use nail washing water to remove the traces of adhesive tape, we must pay attention to protect the objects with traces from corrosion. Scope of application: the surface of the objects with long-term existence, large area, difficult to clean, well and not easy to be corroded of offset printing

9. Use hand cream to remove the adhesive: first tear off the surface of the printed products, and then squeeze some hand cream on it, slowly rub with your thumb, rub it for a while to rub off the sticky residual glue. Just slow down. Hand cream is a kind of grease, which is incompatible with glue. Degumming uses this property. The material is easy to find and easy to remove.

10. Eraser eraser offset: we often used this method when we were children at school. When we wiped with eraser, the rubber drunk crumbs could just stick down the glue traces. The scope of application: it is used for small area and newly left traces. It is useless for large and accumulated tape traces.

11. Computer cleaner erasing offset: usually used to wipe camera lens and computer screen cleaner can also be used to erase tape traces. Scope of application: it is very effective for smooth items.

12. The time-saving and labor-saving 'degumming agent', also known as the 'self-adhesive economic remover', is sold in some auto parts stores. Spray the traces of the tape and it will be wiped off soon. Scope of application: a large area of hard to remove offset, but if you don't often encounter the trouble of tape trace, you don't need to buy a bottle specially.