4hw.com.cn: the mobile phone film can protect the screen of the mobile phone from getting dirty and broken. Many people stick the film to the mobile phone by themselves, but no matter the plastic film or the toughened film is stuck to the mobile phone, once there is a small bubble in it, it is hard to see. Is there any good way to remove the bubble in the mobile phone film?
How to remove bubbles in mobile phone film
In order to protect the screen of smart phones, everyone likes to put film on the screen. Because the film needs a certain amount of technology, it will generate bubbles if it is not well pasted. Today, Xiaobian will teach you how to remove the bubbles in the film. Let's get to know each other!
Removal method of bubble in plastic film:
1. Preparation tools: scissors and transparent tape, and a small piece of cloth
2. First, use a small cloth to push out the bubbles that can be squeezed out. Fold the cloth a few times and push the bubbles with its edges.
3. There are still bubbles that can't be pushed off. Why can't they be pushed out? Because there is dust, it's the dust that forms bubbles in it. We can remove the bubbles if we take out the ash method.
4. Cut the transparent tape one to two inches long and stick it next to the dust bubble on the film. Then cut a small section of the transparent tape on the adhesive side.
5. At this time, use one hand to pull up the transparent tape pasted on the film, and use it to pull up a seam of the film. As long as one seam is pulled, it can let the tape of the other hand in, but it should be noted that it is too big to pull in more dust.
6. After pulling it up, you can see whether there is dust on the film or on the screen of the mobile phone. Look carefully. The dust is very small, and then use the transparent tape on the other hand to stick the dust. The dust will stick out. There is no bubble. We remove the other dust in the same way.
Removal method of bubbles in toughened film:
Method 1: blow with a blower
The method is to soften the tempered film with the heat of the blower, blow the bubbles with hot air for a period of time, then press the bubbles for a period of time, repeatedly, so that the tempered film is easier to fit the screen of the mobile phone.
Advantage: the bubbles in the screen are easy to remove.
Disadvantages: it is easy to damage the screen if the time and heat of blowing are not well grasped. This method has a good effect in combination with one method.
Method 2: clamp
Find a big clip. Before going to bed at night, hold the bubble on the edge of the mobile screen. After getting up the next morning, I was surprised to find that the bubble disappeared!
Advantages: simple, easy to find and buy tools.
Disadvantages: if the clip slips accidentally, the edge of the mobile phone will be scratched by the iron edge of the clip, so the owner accidentally damages the paint of the mobile phone.
Method 3: use human body lubricant or liquid glue
The phenomenon is that there are always bubbles on the edge of the screen. When you press it down, the bubbles are gone, but they will appear again later. This kind of bubble is often distributed on the edge of the screen, and air always enters through the gap between the toughened film and the screen.
The method of use is to take a small amount of liquid on toothpick and other objects, gently open the edge bubble, force the liquid into the bubble slowly, so that the liquid fills the gap between the screen and the toughened film. Do not forget to press the bubble during this method is very good, not much damage to the phone. But there are some technical requirements.