4hw.com.cn: washing machine is an electrical appliance we often use in our life. But many people reflect that when they use the washing machine to wash their clothes, they find that the water inflow speed of the washing machine is very slow, and it took more than 10 minutes to complete the water inflow, so what is the reason for the slow water inflow of the washing machine? Let's get to know next!
The reason why the water in Haier washing machine is slow
1. Foreign matters block the filter screen of water inlet pipe
There are also many sundries in the tap water. If the washing machine is used for a long time, there is a filter screen at the water inlet of the washing machine to specifically filter out the foreign matters in the water. If there are too many foreign matters accumulated on it, the filter screen will be blocked, and the water inlet speed will be slower.
2. Serious bending of water inlet pipe
When using, the water inlet pipe should be kept smooth, not too curved or circuitous, which is easy to slow the flow of water. The water inlet pipe should not be too short or too long, and try to ensure that the water inlet pipe is straight.
3. Low water pressure of tap water
Pull out the water inlet pipe, and observe whether the water flowing out of the faucet of the washing machine is too small. If the water pressure of the tap water itself is small, the water inlet speed will be slower naturally. It is recommended to wait until the water pressure is normal.
The reason of no water in washing machine and its solution
1. If the washing machine can not be opened for water, first check whether the water inlet valve is blocked by dirt. Be careful when unscrewing, it is easy to be damaged, and see whether there is a dirt blockage on the filter screen.
2. Measure whether the water inlet valve has a voltage of 220V with a voltage block. If there is no voltage of 220V, it is a problem with the program controller. If there is, take down the water inlet valve and remove it to measure the resistance of the water inlet valve. The normal value is 3.8k.
3. Turn to the voltage block, and check whether there is a voltage of 220V. We can see that there is a voltage of 220V. This means that the non water is caused by the water inlet valve, not by the external power supply. We unplug both ends of the socket, and then use the resistance block to measure whether it is 3.8k. We find that it is infinite.
4. The coil is open, the coil is open, the voltage is connected inside, there is no action of closing, and water cannot flow in, so the water inlet valve must be replaced, so the water inlet valve must be replaced.
5. If the coil is in good condition and the voltage meets the standard, the valve core inside may be rusty if it still can't enter the water. You need to replace it with a new one or you need to remove the whole valve core and clean it again. Now we have installed this one, and then plug in the power cord again. The fault that the water inlet valve can't enter the water due to the open circuit is eliminated.
When using the washing machine to wash clothes, I found that the water inflow speed of the washing machine was very slow, and it took more than 10 minutes to complete the water inflow. What's the matter.
Solutions to common problems of washing machine
1. The washing machine shakes dry and makes too much noise
During the installation of the washing machine, the transport bolts or packaging are not removed.
There is no adjustment of the bottom adjustment foot of the body, and the washing machine is not placed stably.
There are too few clothes put into the washing machine, so it is easy to shake when dehydrated.
2. Washing machine fails to start
The door of the washing machine is not closed.
The power supply of the washing machine is not plugged in or properly plugged in.
The "appointment" procedure is selected, and the washing machine can only be washed after the fixed time.
3. Water inlet and drainage during cleaning
Some washing machines use the upper drainage method to drain water. If the end of the drain pipe is too low, this situation will occur. The only way is to raise the end of the drain.
4. No drainage after washing
This phenomenon may occur when the drain pipe is squeezed, the drain pipe is blocked, the function selection is wrong, and the distribution of clothes in the cylinder is uneven.