Sihai network

How to wash razor clam quickly and cleanly in summer? How to make razor quickly spit sand?

The most common food for night market snacks in summer is fried razor clam. However, the health condition of night market is worrying. Although razor clam tastes delicious, it is difficult to clean, and it is very disappointing to eat mud. So how can the mud in razor clam be cleaned out?

Cleaning and soaking:

Wash the razor with water first, then prepare a basin of water, put some salt to boil. Then, put the cleaned razor clam into the basin, and pay attention to water change. After the third time of water change, add a drop of oil into the water and mix well. (this article is exclusively compiled by WYH, editor of sihai.com. If you need to reprint it, please indicate the source and source. Related article link: http://www.4hw.com.cn/life/jujia.html)

There are several points to note in this step:

First, the amount of clear water should not be too much, just not over razor clam, which is more convenient for razor to spit out sediment.

Second, the amount of salt should not be too much, nor too little, saltiness should be tasted with the mouth, just as normal food saltiness. Because there is less salt, the razor doesn't spit out sediment, but if the water is too salty, the razor will die soon. In addition, the salt is best to use sea salt. The boss who sells razor clams is prepared and free.

3. Adding a little oil to the water can insulate the oxygen and make the razor spit out the mud faster. But the amount of oil must be less, just a few drops of water in a basin. If used too much, the razor will die soon.

4. In order to prevent the razor from sucking back the sediment, put the razor in the water filtering basket or the leakage basket, and then put the water filtering basket or the leakage basket in the water, and put chopsticks on the bottom. In this way, the mud will sink to the bottom of the water and will not be sucked back by razor clam. (this article is exclusively compiled by WYH, editor of sihai.com. If you need to reprint it, please indicate the source and source. Related article link: http://www.4hw.com.cn/life/jujia.html)

Water change sterilization:

After about 20 to 30 minutes, you will see the razor begin to spit water desperately. After about 2-3 hours, the mud in the razor clam will be spit clean, and the water should be changed several times. In addition, a little vinegar can be added into the water about 1 hour after the razor spits out water, which can kill the halophilic bacteria and taste more hygienic.

Sediment discharge:

Take out the razor clam that spits out all the sediment, wash it repeatedly with light salt water, clean the dirt on the shell, and control the moisture to make dishes.

If you want to be cleaner, you can scald the razor in the boiling water pot, take out the razor meat, tear off the black line on it, remove the black 'sandbag', squeeze the suction pipe of the razor by hand, squeeze out the dirt inside, and then rinse it with water.

Final remedy:

If you don't follow the above steps, the boiled razor clam still has mud and mud, then teach you a way of first aid, just remove the sandbag of razor clam, that's OK, this method is suitable for taking only razor meat, when the time is tight.