Now there are many high-rise buildings, and there are some small high-rise buildings with dozens of floors. If the water pressure in the middle and high-rise buildings is insufficient, our quality of life will be greatly reduced. Therefore, it is necessary to test the water pressure when the decoration of the new house is completed, but not everyone is a professional, and some people know little about this, Let's introduce how to test the water pressure and how to deal with the low water pressure?
How to test the water pressure?
1. Usually, we test the water pressure of the decorated house after the completion of hydropower decoration and before the plastering construction. Before testing the water pressure, it is necessary to plug all pipeline outlets and close the water valve at the same time.
2. Then connect the cold and hot water in series and reserve two pipe orifices. One is equipped with a pressure gauge and the other is equipped with a special beater.
3. After the preparation work is completed, the beater can be opened and the water compressor can be connected to the water pipe. When the pressure gauge has been stable above a value, the beater can be removed.
4. Next, observe the pressure value. If it is still the same value after a few days, it will appear that there is no water leakage in the waterways at home, and we can carry out masonry decoration normally.
What if the water pressure in the house is too low?
1. If the water pressure of the house is too low, we need to check whether the water pipe is blocked. It is best to dredge the water tank and water pipe regularly and replace the faucet and other parts, so as to avoid the situation of too low water pressure.
2. The water pressure of the house is too low. We also need to check whether there is water leakage in the water pipe, because water leakage will seriously reduce the simplicity of the water pipe. We need to check the water pipe section by section, especially the water pipe is a dead corner to see whether there is water leakage.
3. If the water pressure in the house is too low because the diameter of the water pipe is too large or too small, we need to choose the water pipe with suitable diameter, and try to shorten the length and curve of the pipe when installing the water pipe.
4. If the water pressure is too low, we can also install a booster pump, which can increase the water pressure of the house to a certain extent.