How to clean cement points on ceramic tiles
4hw.com.cn: the completion of house decoration does not mean that it has been completed. There are still many small problems that need technical treatment. The cement on the ceramic tile is a no small problem, because the longer it takes, the more difficult it is to clean up. Let's look at the cleaning methods together.
How to remove the cement on the ceramic tile
The longer the cement on the ceramic tile adheres, the greater the humidity, the more difficult it is to remove it completely. Try the following methods:
Removal of hydrochloric acid mixed solution
Mix hydrochloric acid or phosphoric acid solution with water in the ratio of 1:5 (if the cement is thick, drop some hydrochloric acid or phosphoric acid solution directly on it first). Pour the mixed solution on it, then sprinkle saw foam, and clean it with a wooden shovel (do not use metal ones, which will leave traces, let alone steel wire balls for brushing the pot). When shoveling, you can also wet the cement slurry with a rag. Pay attention to cleaning as you shovel. Generally, it can be removed by rubbing several times.
Toilet liquid removal
The cement on the ceramic tile can be washed away with toilet liquid. Even the cheapest one has a good effect. It will fall off as soon as it is poured up, and it will not damage the brick surface.
Professional cleaning agent
For example, a thin layer of concrete cleaning agent. It is used to clean the gray matter, lime residue and cement thin layer on ceramic tiles (glazed tiles, full body tiles, vitrified tiles and polished tiles), clear water tiles, clay products and natural stones.
Toothpaste removes small stains
If there is a small amount of cement stain in the ceramic tile and gap, it is recommended to clean it with toothpaste, which has a strong cleaning effect. First, squeeze an appropriate amount of toothpaste on the brush, determine the amount of toothpaste used according to the size of the stain at the joint, and then brush the joint of the ceramic tile directly. When brushing the joint of the ceramic tile, brush along the direction of the joint of the ceramic tile, so as to clean the stain.
Various plastic cards
The cement mark on the ceramic tile can also be used. We usually contact various membership cards. Don't underestimate this card. It plays a wonderful role in dealing with the cement mark on the ceramic tile. Scraping the card against the place with the cement mark can not only scrape very clean and fast, but also rotate 360 degrees, and will not produce any sharp marks on the ceramic tile surface, Finally, wipe it gently with a rag.
Precautions for removing tile cement
1. Avoid using metal shovel, steel ball and other metal objects to remove the cement, so as not to damage the glaze and leave ugly marks.
2. When using acid cleaner, be sure to pay attention to the mixing proportion and avoid pouring it directly on the stained surface of ceramic tile to avoid damaging the glaze.
How does the water pipe under the floor tile leak
The water pipe under the floor tile leaks, which may be caused by its own aging, loose parts, or non-standard installation. In case of water pipe leakage, the normal operation steps are described as follows:
1. Find the main leak first. First dry the floor and observe the position of the water.
2. Then cut off the floor tiles around the water outlet point. If the water outlet point is found, turn off the main tap water switch, turn on the low position tap and drain the water in the water pipe. Open the water pipe in front of the leaking water pipe, blow smoke into the water supply pipe, see where the smoke comes out, and mark the position.
Connect the water pipe pulled out in front, pull out the water pipe from behind the leaking section, and then repeat the original smoke blowing method to see where the smoke is coming out, and remember the smoke location. According to the smoke location recorded in these two times, you can know which water pipes are leaking.
3. If no water outlet is found, all the floor tiles along the water pipe can only be removed. After the water outlet is found, continue the second step. After repairing the water pipe, re paste the corresponding floor tiles. Or rearrange the water pipes and discard the leaking pipes.
4. It is recommended to find professional personnel to avoid unnecessary losses.