Sihai network

How to deal with the fading of wool coat

How to deal with the fading of wool coat

Www.sihai.com: in autumn and winter, many friends like to wear cashmere coats, simple and generous. Wool coats fade after wearing for a long time, but what about the fading of wool coats? Now let's take a look at the wool coat fading tips~

Does wool coat fade normally

Woolen fabric refers to the fabric made of wool or wool, polyester, viscose, acrylic, etc. For the faded woolen overcoat, the wool content of the garment is high, and the color fixation of this natural fiber is poor, so the different mixing ratio with other chemical fibers leads to completely different dye properties for each of them, which leads to different color fading rate.

How to do with the fading of wool coat

Method 1: add salt

When washing the woolen coat, you can add a small amount of salt in the water, then soak the coat for a few minutes, and finally use neutral detergent to clean it, which can remedy the problem of woolen coat fading.

Method 2: add vinegar

When washing dark colored (such as black, blue or other colored) woolen coats, you can add a few drops of vinegar when washing. The method is to add some ordinary vinegar to the washing water before washing these clothes. Just soak for a while! But the amount of vinegar should not be too much, otherwise it is easy to dye light colored clothes. If you can often clean clothes like this, you can ensure the color of clothes as bright as new!

Method 3: diluted oxalic acid cleaning

If the colored wool coat fades due to sweat, you can dilute the oxalic acid concentration to 2% with water, then brush it with a toothbrush, rinse it, and repeat the above steps for 2-3 times.

Method 4: add borax solution

In fact, a lot of wool coats are discolored because they haven't been worn for a long time and are properly maintained. This situation can also be solved to restore the original color of the coat! As long as you soak your woolen coat in borax solution for 1 hour, the color of your woolen coat will be the same as the new one!

Methods five flower water cleaning method

First, clean the woolen coat according to the conventional method. In the last rinse, drop a few drops of toilet water into the clean water, and then soak the cleaned woolen coat for ten minutes. This can also play the role of sterilization and sweat removal Oh!

Prevention of color fading method 5: anti air method

This method is the most simple and commonly used, especially for some dark wool coats. Turn the wool coat back to dry, which can avoid the discoloration caused by long-term ultraviolet radiation and affect the gloss. If possible, try to dry the wool coat in a dark and ventilated place.

Tips:

If the wool fabric is dirty, it must be cleaned immediately to avoid leaving traces. The longer the stain stays on it, the less likely it will be washed off; Moreover, as time goes on, the stains will penetrate into the fibers, so they will rub hard when cleaning, which is more likely to cause damage to the clothes.

For local slight stains, try to use a towel dipped in neutral detergent or water solution of silk wool special detergent to gently wipe the hair surface. After removing the stains, use a clean towel dipped in clean water to clear the residual detergent solution in the same way. It can be repeated several times. During the operation, try not to wet the leather board and dry it in a cool place in time.

If you wash with water, you should pay attention to the following points:

1. Cashmere is not alkali resistant. If washed with neutral detergent without enzyme, it is better to use wool detergent.

2. Wool fabric will shrink and deform in the water solution of more than 30 degrees. Gu Yi should soak it in cold water for a short time, wash it at a temperature of no more than 40 degrees, knead it gently and avoid rubbing it vigorously.

3. Use squeeze washing, avoid twisting, squeeze to remove water, spread it flat or hang it half in the shade; Wet plastic or semi dry plastic, can remove wrinkles, do not expose to the sun;

4. Softener should be used to maintain soft handle and antistatic.

5. Do not use chlorine containing bleaching solution, can use oxygen-containing color bleaching.