Sihai network

Breeding methods and points for attention: high temperature and high humidity environment

In daily life, in the street, in the park or at a friend's home, you can often see the figure of butterfly plum. Its beauty has attracted countless people, and it can't help sprouting the mood of breeding butterfly plum. However, how to breed butterfly plum? Please read down with me with your questions!

Pink Bougainvillea breeding method (basic knowledge): the best breeding time: the best breeding time of Bougainvillea is in spring and autumn.

The best growing soil: the common cultivation medium of iris is mainly water grass and moss.

Growth humidity requirements: Butterfly plum should be cultivated and maintained in a ventilated and high humidity environment, and the humidity can be maintained at about 60%.

The best growth temperature: Butterfly plum like high temperature and humidity environment, the best growth temperature is 16 ℃ ~ 30 ℃.

The best growth light: Although Bougainvillea prefers shade, it is still necessary to make the orchid plants accept part of the light, especially before and after the flowering period. Appropriate light can promote the flowering of Bougainvillea and make the flowers beautiful and lasting. Generally, it should be placed in the room where there is scattered light instead of direct sunlight.

Notes for breeding iris purplish red: apply fertilizer: mix the liquid fertilizer slightly lower than the specified concentration, once a week, which is equivalent to watering. But do not apply fertilizer when flowers are in bloom or when the temperature is below 15 ℃ in winter.

Watering points: control the amount of water. If the weather is too dry, you can water it once every 2-3 days, depending on the dry and wet conditions of the basin soil.

Pruning tips: after the flower withers, the flower branches should be removed immediately to avoid consuming nutrients, which is conducive to the development and flowering of new flower branches.

Pot soil replacement: the old plants that have been potted for 3 to 4 years need to be renewed, and the pot soil replacement is usually carried out in September.

Breeding points: Butterfly plum mainly depends on cutting propagation. Cut a branch 3-4cm long from a large plant, leave 4-5 leaves, and put them into sand and soil together. After 9 days, they can bask in the sun, and take root between 14-21 days.

Pest control: the normal growth of butterfly plum needs flowing fresh air, so the ventilation of domestic Hu diemei must be good, especially in the summer high humidity period, good ventilation must be used to prevent summer heat, and at the same time, the infection of pests and diseases can be avoided. The following are the prevention and control methods: 1. Horticultural prevention and control: the plants should be ventilated and transparent to avoid high humidity; do not directly spray water on the plants to avoid splashing water droplets to spread the disease; do not select cuttings on the diseased plants to remove all the diseased leaves and branches to avoid contaminated leaves with soil with bacteria.

2. Chemical control: spraying agricultural streptomycin 1000 units, or using 14% glucuronide 300 times solution, or 50% xiaojunling 1000 times solution.

Purple Pink Butterfly plum experience of breeding butterfly plum: at the turn of autumn and winter and spring, and when the temperature is low in winter, attention should be paid to increasing the temperature. Generally, it is not difficult to reach the temperature in a room with heating equipment in winter, but attention should be paid not to put the flowers directly on the radiator or too close to it. In summer, when the temperature is high, we need to cool down and pay attention to ventilation. If the temperature is higher than 32 ℃, bougainvillea will usually enter a semi dormant state, and continuous high temperature should be avoided. Before and after the Spring Festival is the full flowering period, appropriate cooling can extend the viewing time, and the night temperature at flowering is best controlled between 13 ℃ and 16 ℃, but not lower than 13 ℃.