Milan is a kind of warm plant, like sunny place. As long as the sun is good, the flowers in Milan are very beautiful. When Milan blooms, it smells like orchids. You come to this article, I believe you must be very interested in Milan's breeding methods and breeding matters needing attention. So let's look down^_^
Milan flowering Milan breeding methods (basic knowledge): the best breeding time: Milan the best breeding time in June to August, about 2 months to start rooting.
The best growing soil: the acid soil is the best, and the corrosive substance is mainly rotten leaves. You can also buy the special fertilizer on the market.
Growth humidity requirements: Milan likes to be wet, so it needs timely watering, especially during the growth period. Avoid waterlogging, because if too much watering will cause a series of problems, such as yellow leaves, rotten roots. The culture soil is slightly dry and then watered, which needs to be watered thoroughly at one time. Spray the leaves properly in summer.
The optimum growth temperature is 20 ℃～ 25 ℃. Under normal circumstances, the sun is abundant and the temperature is high (about 30 ℃), and the flowers will have strong fragrance. In summer, when it's hottest, water it properly to cool it down. Milan is originally tropical, not resistant to low temperature. Generally, it is necessary to move into the room during the frost fall to the beginning of winter, and put it on the windowsill or desktop facing the sun. The indoor temperature should be kept at 8-10 ℃ and not lower than 5 ℃.
The best growth light: Milan likes warm, sunny and fat. Milan likes warm climate, so it is generally recommended to keep it in greenhouse. It can be put outside in summer, but it should be properly shaded.
Notes for Milan flower planting and breeding Milan: appropriate application of fertilizer: Milan does not require high fertilizer, but because it blooms many times a year, it causes nutrient deficiency, so it needs to apply a little fertilizer in time after flowering, not too much.
Main points of propagation: cutting, high branch pressing or sowing are used for propagation.
Layering: high altitude layering is the main method. In the plum rain season, annual lignified branches are selected. The ring peeling is 1cm wide at 20cm of the base. Moss or peat is applied to the girdling part, and then the film is tied up and down. It can take root in 2-3 months.
Cutting: about 10 cm of the top twigs were cut from June to August and inserted into peat. Rooting began 2 months later.
Pruning gist: Milan flower is usually pruned when it is moved out of the room in spring. The dead branches, diseased branches and thin and over dense branches should be cut off to strengthen ventilation and light transmission, and let nutrients concentrate on the left branches, so as to promote the peaceful coexistence and flowering of plants. During the growth period, there is no need to prune, but when the tree potential is unbalanced, the branches protruding from the crown are cut short.
Pot soil replacement: when transplanting, the original soil should be mixed into the new flowerpot. Generally, 70% of the original soil and 30% of the new soil should be used, and then the magnolia flowers should be moved in, so as to prevent the death of Milan flower due to the sudden change of environment.
Pest control:
1. Aphids spray plants with cigarette butts or hot pepper water. It can also be sprayed with 800 times of mieyiling. If the amount is small, it can be manually brushed with a small brush.
2. The beetles were sprayed with 1500 times of the insecticide solution, and when the amount was small, the beetles could be removed manually with a brush.
3. The spider was sprayed with DDVP or dimethoate 2000 times.
4. The disease is easy to occur due to high temperature, high humidity and poor ventilation.
Milan bonsai small weaving breeding Milan experience: everyone bought Milan in the flower market is cultivated in the greenhouse. Constant temperature and humidity, sufficient light and special management, it is suitable for the growth of Milan. After carrying home, put it on the balcony at home, high temperature and hot wind in summer, large temperature difference between morning and night, poor ventilation and improper watering, all of which can easily lead to leaf falling in Milan. There are reasons for improper care, but also Milan's adaptive process in the process of suddenly changing the growth environment. As a result, most people buy back Milan from the market, and they have to leave a large area of leaves within a week, and finally become "bare legs".